SW 2014 Sketch inference points

[dabiz7]

In Sketch mode, when I place the cursor along a line, why would the midpoint relation inference not pop up?
Also, how do I place <x> number sketch points evenly spaced along a curve? or just at the midpoint?
Also, why is it that the intersection of two lines on seperate sketches can not be picked witht he cursor to make a curve/line?

 

[CorBlimeyLimey]

In Sketch mode, when I place the cursor along a line, why would the midpoint relation inference not pop up?

Make sure the Selection Filter is not set to exclude midpoints.

Also, how do I place <x> number sketch points evenly spaced along a curve? or just at the midpoint?

Check the Help files for Reference Points

http://help.solidworks.com/2014/English/solidworks/sldworks/c_reference_points.htm

http://help.solidworks.com/2014/Eng...ng_Multiple_Reference_Points_Along_Curves.htm

Also, why is it that the intersection of two lines on seperate sketches can not be picked with the cursor to make a curve/line?

The intersection of two lines can be selected. Make note of the cursor icon. It is not as obvious as other selected points which are highlighted orange.

 

[dabiz7]

Two seperate 3D sketches on the same surface....why can't I go Ref POints, Intersection, pick both 3D sketch lines, create point????
It says Rebuild errors, failed to create point