SW API: creating and positioning NOTES in part model sketch

[SWVB101]

SW API - VB6 - SW01+
Has anyone had any luck creating and positioning NOTES in a SW part model and/or sketch...

I believe you are supposed to use ModelDoc2:InsertNewNote3 to insert the note...

Then use the selection manager to select the newly created note...

then use Note:SetTextPoint to position the note...

Does anyone have a better method of doing this?

(I tend to overlook commands at times)

Thanks,
--Josh--[/b]

 

[dsi]

I think you have it. The coordinates are not available until you insert the note.

DimensionalSolutions@Core.com
While I welcome e-mail messages, please post all thread activity in these forums for the benefit of all members.