Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

SW IGES export to FeatureCAM

Thread starter szabes
Start date Dec 14, 2005

Status: Not open for further replies.

Dec 14, 2005

szabes

Mechanical

Hello, I'm trying to export SW 2004 sketches and or curves to FeatureCAM in IGES format. The SW entities always come into FeatureCAM as multiple entities, not as "one" curve. This causes me to re-pick every entity in FeatureCAM to re-join them into a continuos curve - very time consuming.
Does anyone know if there are SW IGES export settings that will do this? I've tried all of the settings in the SW export dialog box.
thank you