Greetings Civilization,
I've just noticed that on some assemblies, after I close the viewing window, there are still additional parts open that I never opened. These parts belong to the assembly that I just closed. I'm assuming these parts automatically opened when I open the assembly. Does anyone know of options that control such behavior in the opening of assemblies?
Thanks,
Tom
Failure is a prerequisite of successful design
I've just noticed that on some assemblies, after I close the viewing window, there are still additional parts open that I never opened. These parts belong to the assembly that I just closed. I'm assuming these parts automatically opened when I open the assembly. Does anyone know of options that control such behavior in the opening of assemblies?
Thanks,
Tom
Failure is a prerequisite of successful design