-
1
- #1
CorBlimeyLimey
Mechanical
A question for SW06 users ... In SW06 a 'rounded end' slot can be created using a single line in a 2D sketch. Does that feature also apply in a 3D sketch? eg. a radial slot in the wall of a tube or OD of a round bar.
Making the best use of this Forum. faq559-716
How to get answers to your SW questions. faq559-1091
Helpful SW websites every user should be aware of. faq559-520
Making the best use of this Forum. faq559-716
How to get answers to your SW questions. faq559-1091
Helpful SW websites every user should be aware of. faq559-520