Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

SW2004 part not being read with FeatureCAM 2004

Thread starter phlyx
Start date Dec 4, 2003

Status: Not open for further replies.

Dec 4, 2003

phlyx

Mechanical

After we upgraded to SW2004 SP1.0 and we also upgraded our shop to FeatureCAM 2004 we found we could not directly import SLDPRT files into FeatureCAM. After contacting FeatureCAM we were told this :
---------------------------------------
You need to download the 10.3 version of FeatureCAM to get the ability to read SolidWorks 2004 file

You can get V10.3 from our web site or by following this link
http://www.featurecam.com/support/download.htm.
---------------------------------------
So if anyone is having problems reading SW2004 SLDPRT files with FeatureCAM, be sure you visit their site and upgrade!