Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

sweep cut in two planes

Status
Not open for further replies.

illustrator15

Mechanical
Apr 4, 2011
16
DK
Hi,

I am using NX 7.5. I want to make a smooth transitioned profile by cutting the area mentioned in the attached picture. Please tell me how to do it. I tried edge blend but it does not work because I want to remove a bit more material from the area mentioned.

Thanks,
 
Replies continue below

Recommended for you

I see the red arc in the picture, but can you show, or explain, how it gets swept
 
If we had the model we might be able to give it a try, but it would be hard to advise anything from only a picture.

That being said, your best bet might be to model a 'tool' body with a concave version of the shape that you're looking for and then subtract it from the model.

John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
 
Hi,

Sometimes revolve with a required profile works instead of going into advanced commands. :). It worked for me.

Thanks anyways for your help guys!
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top