treddie
Computer
- Dec 17, 2005
- 417
Hello.
Has anyone seen this problem before in a Creo2 Sweep? Please see the attached image.
Notice that the cut is not following Chain-2 accurately, but instead has "the jitters".
I have tried adjusting the Sweep options, but nothing has any effect. Seems like if I specify
a trajectory, then it should be faithfully followed. It is acting as if there is some missing constraint or something.
Has anyone seen this problem before in a Creo2 Sweep? Please see the attached image.
Notice that the cut is not following Chain-2 accurately, but instead has "the jitters".
I have tried adjusting the Sweep options, but nothing has any effect. Seems like if I specify
a trajectory, then it should be faithfully followed. It is acting as if there is some missing constraint or something.