switch part tool for NX10

[mjmjide]

CNSZU,

Just sorted through an old thread (thread561-351988). Any chance you're still using your switchpart tool and have updated it to support NX10?
I installed it as instructed and got the following errors. I've been looking for this functionality and am hoping this is the solution.

 

[CNSZU]

Attached is the Switch Part Tool v.1.4.

-Window position is saved
-No need to manually input journal directory
-Fixed bugs

Try it, it should work now.


NX10.0 Win8.1 64bit i7-3770K 16GB QuadroK2200

 

[mjmjide]

Thank you! This worked great. Having the thumbnail preview when switching and the product structure selection is super convenient.
Assuming its not just my system, my only constructive comment (from strictly a never satisfied user/consumer perspective) is that the startup of the tool while it builds the selection is slow. If it was able to compile and display the selection menu more quickly, I would give it a 5 of 5 star rating rather than a 4.5.

Thanks again for your reply and helpful programming!