HayaNaji
Marine/Ocean
- Jun 9, 2016
- 14
Hello Guys
I'm a beginner in Abaqus-based python scripts
I wrote this as part of a script to partition faces, I want to check if this is right or not. because when i run the script i got the syntax error message.
mdb.models['Model-1'].parts['Sec1'].PartitionFaceBySketchThruAll(faces=
mdb.models['Model-1'].parts['Sec1'].faces.getByBoundingBox((0.5, -0.1,
0.0, ,1.2, -3.4, 2.0), (0.2, -3.6, 0.0, 0.8,-6.9,2.0),(0.8,-7.1,0.0,.06,-10.4,2.0),(0.06,-10.6,0.0,0.0,-12.5,2.0)), sketch=mdb.models['Model-1'].sketches['__profile__'],
sketchPlane=mdb.models['Model-1'].parts['Sec1'].faces.findAt((0.0, -3.5,
1.0), ), sketchPlaneSide=SIDE1, sketchUpEdge=
mdb.models['Model-1'].parts['Sec1'].edges.findAt((0.0, -3.5, 2.0), ))
I'm a beginner in Abaqus-based python scripts
I wrote this as part of a script to partition faces, I want to check if this is right or not. because when i run the script i got the syntax error message.
mdb.models['Model-1'].parts['Sec1'].PartitionFaceBySketchThruAll(faces=
mdb.models['Model-1'].parts['Sec1'].faces.getByBoundingBox((0.5, -0.1,
0.0, ,1.2, -3.4, 2.0), (0.2, -3.6, 0.0, 0.8,-6.9,2.0),(0.8,-7.1,0.0,.06,-10.4,2.0),(0.06,-10.6,0.0,0.0,-12.5,2.0)), sketch=mdb.models['Model-1'].sketches['__profile__'],
sketchPlane=mdb.models['Model-1'].parts['Sec1'].faces.findAt((0.0, -3.5,
1.0), ), sketchPlaneSide=SIDE1, sketchUpEdge=
mdb.models['Model-1'].parts['Sec1'].edges.findAt((0.0, -3.5, 2.0), ))