laserguy04
Mechanical
Hi we have an Amada laser and the balls on the table are marking the sheets quite bad, do you have any suggestions to prevent this?
Regards,
Jamie.
Regards,
Jamie.
Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Table Balls Marking Sheet
- Thread starter laserguy04
- Start date
- Status
Be sure it's the balls, We have 5 Amada Punches, one punch/laser combo, The turret is the biggest culprit.
Take a new sheet of metal, roll it in then across the surface, look atthe scratch pattern, this should indicate where exavtly the scratches are happening.
Take a new sheet of metal, roll it in then across the surface, look atthe scratch pattern, this should indicate where exavtly the scratches are happening.
- Status
Similar threads
- Locked
- Question
- Locked
- Helpful tip