Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Tack Weld a Nut 1
- Thread starter Brandy7
- Start date
-
1
- #2
Put a note in the tail if it is a tack to be consumed/removed (such as pre-production setup, etc). If it is not to be consumed/removed for final welding, call it out as an appropriately sized small fillet, and add a note if needed for clarity.
- Status
