Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Tangent lines showing up in cable routing

Status
Not open for further replies.

cinnamongirl

Mechanical
Joined
Jan 18, 2011
Messages
106
Location
US
I am fairly new to the routing module in SolidWorks. I'm noticing that tangent lines randomly appear on cabling routed along a spline, usually where the spline points are, but sometimes the cables appear smooth. What is the rule that determines whether tangent lines show up? I'd prefer to have smooth cables if possible.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top