OliverManhire
Mechanical
Has anyone seen any models or even acad drawings of these? Fenner make them deliberately hard to copy but are a valuable component for shafts etc
Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Taper Lock Bushes
- Thread starter OliverManhire
- Start date
- Status
- Thread starter
- #3
OliverManhire
Mechanical
Fenner is preferred choice here in Australia, but any will do, mostly all i need is angular position and pcd of the set screws and guide pins. If it's not too much trouble you can email the browning models to engin_eer@hotmail.com. I'm currently looking at a Fenner 8065 285/282 dia.
Thanx for your help
Thanx for your help
- Status
Similar threads
- Locked
- Question
- Locked
- Question