It's my first dealing with "top down" styling, and I need help. I've added tapped holes in a plate, transferred from a mating part. They are shown in the assembly file, but when I go to make the detail print of the part, they dont show up. What am I doing wrong?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Tapped holes in sldassy parts dont show up in detail views
- Thread starter borsht
- Start date
Mandrake22
Mechanical
It sounds like you have added an "assembly feature" and have not edited the part in the context of the assembly.
Delete your feature and try again by selecting the part while in the assembly and then clicking the Edit, Part button or selecting this from the top menu. Work on your part just as if it were the only file open. When done, click the Edit, Part button off. Save the assy. Open the part and your features should be there.
Delete your feature and try again by selecting the part while in the assembly and then clicking the Edit, Part button or selecting this from the top menu. Work on your part just as if it were the only file open. When done, click the Edit, Part button off. Save the assy. Open the part and your features should be there.
- Status
Similar threads
- Question