Hi,
I'm using CST Microwave Studio for the first time.I've drawn an optical buried channel waveguide with refractive indices n1 and n2 (n2 ist bigger than n1;n2 is the refractive indice of the core and n1of the cladding)and excited it through a port(I've defined only one port).The waveguide has a width of 0.25 micrometer and Height of 0.32 micrometer.I've set the boundaries conditions to XZ-Plane(electric or magnetic)and the minimum frequency ist 100e12Hz and the maximum 287.096e12Hz.CST Microwave Studio calculates the port modes,but I don't know whether it is a TE-Mode or a TM-Mode.How can I make the difference?
I need Help PLEEEEEASE !!!
I'm using CST Microwave Studio for the first time.I've drawn an optical buried channel waveguide with refractive indices n1 and n2 (n2 ist bigger than n1;n2 is the refractive indice of the core and n1of the cladding)and excited it through a port(I've defined only one port).The waveguide has a width of 0.25 micrometer and Height of 0.32 micrometer.I've set the boundaries conditions to XZ-Plane(electric or magnetic)and the minimum frequency ist 100e12Hz and the maximum 287.096e12Hz.CST Microwave Studio calculates the port modes,but I don't know whether it is a TE-Mode or a TM-Mode.How can I make the difference?
I need Help PLEEEEEASE !!!
