Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
TeamCenter JT files to UGNX6
- Thread starter edc2be
- Start date
Arkance/PhoeNX
Mechanical
Yes it is possible, but there is no import for JT.
Instead get him to try File -> Open and change the file type at the bottom of the dialog to JT. It should then be able to open a JT.
It could also be that the JT version being exported is later than the one supported by NX6.
Anthony Galante
Senior Support Engineer
NX4.0.4MP10, NX5.0.0->5.0.6, NX6.0.0->NX6.0.5, NX7.0.0->NX7.0.1 & NX7.5.0.32-> NX7.5.2.5, Beta NX8.0.0.15
Instead get him to try File -> Open and change the file type at the bottom of the dialog to JT. It should then be able to open a JT.
It could also be that the JT version being exported is later than the one supported by NX6.
Anthony Galante
Senior Support Engineer
NX4.0.4MP10, NX5.0.0->5.0.6, NX6.0.0->NX6.0.5, NX7.0.0->NX7.0.1 & NX7.5.0.32-> NX7.5.2.5, Beta NX8.0.0.15
- Status
Similar threads
- Locked
- Question
- Locked