RobLN
Mechanical
- Oct 29, 2003
- 152
Hello - a message to request any information relating to Teamcenter Requirements Manager.
- Has anyone used this for managing their specifications?
- Is there a simple way to get this software component to add in specification part numbers (Items) to an assembly BOM so it will be displayed on a drawing?
- Is it compatible with Word DOCX - 2010?
- Information in the help is a bit limited - any practical guidance on this is appreciated... Help & feedback relating to using this on TC 2007 or TC 8.3 please...
Thank you.
Solid Edge; I-Deas 7 to 12; NX4, NX5 & currently NX6.
- Has anyone used this for managing their specifications?
- Is there a simple way to get this software component to add in specification part numbers (Items) to an assembly BOM so it will be displayed on a drawing?
- Is it compatible with Word DOCX - 2010?
- Information in the help is a bit limited - any practical guidance on this is appreciated... Help & feedback relating to using this on TC 2007 or TC 8.3 please...
Thank you.
Solid Edge; I-Deas 7 to 12; NX4, NX5 & currently NX6.
