Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations Toost on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Teamcenter revisions letters A,B, ... ,Y

Status
Not open for further replies.

Ehaviv

Computer
Jul 2, 2003
1,012
Hi

Is teamcenter revisions letters A,B, ... ,Y
Not includes 2 LETTERS (AA,AB,....,AY) and why.


Thank you.
 
Replies continue below

Recommended for you

That is a setting made by your Teamcenter Administrator. You will have to ask him/her.
Cannot be changed by a "normal" user. The setting is made in the tool (BMIDE)to configure Teamcenter naming rules.

Ronald van den Broek
Senior Application Engineer
Winterthur Gas & Diesel Ltd
NX9 / TC10.1.2

Building new PLM environment from Scratch using NX12 / TC11
 
Typically, revision lettering skips I,O,Q,S,X and Z to eliminate any confusion with numbers or symbols used elsewhere on a drawing.
See ASME Y14.35 - Identifying Revisions on Drawings.


The list of revisions is established at system setup.

"Wildfires are dangerous, hard to control, and economically catastrophic."

Ben Loosli
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor