Tesselation lines in a drawing view??

[D3sign3r]

Im creating views onto my sheet (wormgear shaft), and for some reason, the 'end' views are displaying this line from the center mark to the edge of the page. I cannot seem to delete/hide it. Are they tesselation lines where tangences on a particular point dont quite line?

 

[SBaugh]

Don't hide it delete it. There was a bug in SW04 SP0 that inserted a centermark from the origin to the center of the file. The only way to get rid of it is to remove it and re-add it. Otherwise upgrade to SP1.

Regards

Scott Baugh, CSWP
3DVision Technologies

http://www.3dvisiontech.com

http://www.scottjbaugh.com

faq731-376

 

[D3sign3r]

Actually thats not the problem (i have sp1 anyway). I dont think it has anything to do with the centerline. It just happens to place a line (which i cannot even select), from the center of the part, to the edge of the page. Looks like a kite with the string leading to the corner.

 

[G1DESIGN]

i had this happen twice both times the drawingwas corrupt in that sometimes i could open it and work quite fine on the drg.
then after a while i tried to open the drawing and it just said the drawing was corrupt howebver when i recreated the part and dropped it into the drawing it was a ok

i also tried replacing the sheet, if its the same thing does the line extend from the ctr of a view to a corner of the sheet or from the ctr to corner?

if so it might be the same thing