Text Machining in ugnx 7.5

[holyghost]

Hi All
I trying to do program for a part which have text on a swept part. But I am unable to generate.
Here with I am attaching a JPG please have a look.
Tanking you

 

[Toost]

I think you need to upload an example part.
There are too many "unknowns" in this equation.
Do you run 3-4-5 axis ? is a starter question.
What version of NX ?

Regards,
Tomas

 

[holyghost]

Hi
its 5 axis part UGNX 7.5

 

[markrief]

I'm not sure what was in 7.5, but today to cut just the outlines, use variable axis with point/curve drive method, and set the selection filter to feature curves.

To cut as pockets or bosses, I would use contour profile, with multiple side passes.

Mark Rief
NX CAM Customer Success
Siemens PLM Software