Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

The Difference in hardness between Type II and Type II Anodized coatin

Status
Not open for further replies.
Fibergeek

Fibergeek

Electrical
Sep 22, 2003
2
Many claim that Type III (hardcoat) anodized layers are "harder" than Type II. If this is true, what is the difference in "hardness"? I'm not asking about durability or coating density per se . I'm looking for a number.
 
Status
Not open for further replies.

Similar threads

JoelTXCive
  • Locked
  • Question
Need to Paint a Pipe - SSPC Spec? and Paint Type 1
Replies
13
Views
671
SJones
SJones
clandestinho
  • Locked
  • Question
fungicide for 2K polyurethane coating in marine environment 1
Replies
1
Views
453
TugboatEng
TugboatEng
Bob_3
  • Locked
  • Question
1000 hr salt spray coating 1
Replies
1
Views
559
TugboatEng
TugboatEng
YungPlantEng
  • Locked
  • Question
Thermal Spray Coating - Adherence to cast vs wrought
Replies
0
Views
387
YungPlantEng
YungPlantEng
NorthCivil
  • Locked
  • Question
acrylic paint primer to bitumen membrane (torch on roofing type)
Replies
0
Views
69
NorthCivil
NorthCivil

Part and Inventory Search

Sponsor

Back
Top Bottom