feri.danesh
Civil/Environmental
- Feb 8, 2017
- 1
Hi every one
After simulation of Contact problem regarding to COHESIVE BEHAVIOR i have received a message in Note box in Abaqus :
The interaction property "COHESIVE_LAYOR" has been created
The interaction "general_contact" has been created.
The interaction property "Default" has been created.
in my case There are only 2 surfaces ,which are defined with "COHESIVE_LAYER" property and no other surfaces ,which are located in contact .
the question is ,why should has been created the interaction property "Default" ,although no other in contact located surfaces exist at all??
Regards,
F.Danesh
After simulation of Contact problem regarding to COHESIVE BEHAVIOR i have received a message in Note box in Abaqus :
The interaction property "COHESIVE_LAYOR" has been created
The interaction "general_contact" has been created.
The interaction property "Default" has been created.
in my case There are only 2 surfaces ,which are defined with "COHESIVE_LAYER" property and no other surfaces ,which are located in contact .
the question is ,why should has been created the interaction property "Default" ,although no other in contact located surfaces exist at all??
Regards,
F.Danesh