Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Thermal anaysis

Status
Not open for further replies.

Bobfromoh

Mechanical
Sep 9, 2002
157
I'm using Creo 3. I have a pipe section with 800F
inside temperature, out side is 100F ambient. On the
outside is a convection heat transfer and there should also be
radiation heat transfer but I can't seem to assign
both conditions to the same analysis. How are the two
combined?
 
Replies continue below

Recommended for you

Anyone got any ideas on this subject.
I have been trying to contact PTC but
without success yet?
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor