Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Thickness of tubes Sec IV HG-301.2 and HF-204.3

Status
Not open for further replies.
Konrad

Konrad

Mechanical
May 20, 2002
84
I'm using stainless austenitic tubes welded to stainless tubesheet in a small hot water heater. Does HF-204.3 exempt from HG-301.2(b) 1.5mm minimum thickness?

Thanks
Konrad
 
Status
Not open for further replies.

Similar threads

FAHADRANA
  • Question
WQT for Combination of Welders as per ASME Sec IX
Replies
1
Views
2K
weldstan
weldstan
milosd
  • Question
ASME SB-564 Maximum section thickness for N06625
Replies
1
Views
1K
EdStainless
EdStainless
jayinwww
  • Locked
  • Question
16Cr-11Ni-2.5MoCb Furnace Tubes
Replies
1
Views
78
DVWE
DVWE
LeoSter
  • Question
ASME B16.9 wall thickness tolerance
Replies
2
Views
655
LittleInch
LittleInch
GinBread
  • Locked
  • Question
Warping of Tubesheets and Flanges
Replies
9
Views
205
EdStainless
EdStainless

Part and Inventory Search

Sponsor

Back
Top Bottom