Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Thickness Selections for MDMT calc. of a clamp

Status
Not open for further replies.

juancito

Mechanical
Nov 30, 2000
64
Dear colleagues,

Does any of you know where can I get some hints (or examples) concerning how to select "the" thickness of a not regular geometry like the clamp of a quick openning closure.
Any comment on this regard will be very welcome.
Thanks in advance

JJ

 
Replies continue below

Recommended for you

Please refer ASME Sec VIII Div1 UCS-66 (1)(b)the thickness shall be the thickness of thinner parts joined by weld.

Trust this will help.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor