Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

thread367-72498 Similar to this

Thread starter rsa10
Start date Dec 8, 2020

Status: Not open for further replies.

Dec 8, 2020

rsa10

Aerospace

thread367-72498

Similar to this thread I want to use PEEK as structure element in bending loading. This assembly will be subjected to 170K temperature. Is there any issue in using peek in this temperature range? If someone has property of PEEK in this temperature range it would be helpful for me.