gokul8707
Automotive
- Nov 28, 2015
- 14
thread799-326769
Hi guys..
I too have this problem stated in the previous thread " the imported part contains imprecise geometry
partioning and quad/hex meshing using the medial axis algorithm may fail on imprecise parts". But i ignore those and continue with my simulation.
Is it much necessary to mind that error.. I have also tried many ways to ignore those imprecise parts in abaqus, but it totally changes the geometry. any ideas? I have also attached my .stp file in this mail.
Thanks
gokul
Hi guys..
I too have this problem stated in the previous thread " the imported part contains imprecise geometry
partioning and quad/hex meshing using the medial axis algorithm may fail on imprecise parts". But i ignore those and continue with my simulation.
Is it much necessary to mind that error.. I have also tried many ways to ignore those imprecise parts in abaqus, but it totally changes the geometry. any ideas? I have also attached my .stp file in this mail.
Thanks
gokul