Threaded hole 3D notes to a layer by rule

[alphaguru]

Is there a rule that will place the 3D note created with a threaded hole to a layer? As of right now they do not get placed in any layer and they become cumbersome when view large assemblies. I am speaking about the note that is created with all the hole info, such as drill #, thread type (unc, unf, ect) and depth.

 

[robertib]

In Wildfire 2.0 there is a command to hide the 3d notes

Tools -> Environment & remove the check next to 3D notes.

in config.pro

model_note_display no

 

[robertib]

Also, you can set up a rule to put the notes onto a layer

rules are

Annotation, Annotation Element & Note