knotheadjohn
Mechanical
- Nov 27, 2005
- 2
Hello to All
My question today is. I been installing metal on furnaces - attic over heads and now some commercial jobs My super asked me to try to call in the tie-in metal from the starter pieces that were placed in the curb before the units were set by the rig. To the metal which was installed about 10 feet away. Is their any software program out their where?
I can put in the cfm data, the location of the starter pieces and then the tie-in location
Were it can measure both supply and return fittings without them running into each other? Summer coming and it sounds like a lot of measuring will be heading my way.
My question today is. I been installing metal on furnaces - attic over heads and now some commercial jobs My super asked me to try to call in the tie-in metal from the starter pieces that were placed in the curb before the units were set by the rig. To the metal which was installed about 10 feet away. Is their any software program out their where?
I can put in the cfm data, the location of the starter pieces and then the tie-in location
Were it can measure both supply and return fittings without them running into each other? Summer coming and it sounds like a lot of measuring will be heading my way.
