Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Title Block default settings

Status
Not open for further replies.

dklarz

Mechanical
Mar 31, 2005
89
SolidWorks 2017. Is there a way to change the default settings for weight in title blocks? For example, I have a part that weighs 5.40 lbs. I'd like to drop the decimal places and round up to the nearest pound (6 lbs). How can I do this? Thanks.
 
Replies continue below

Recommended for you

On a side note: if your part weighs 5.40 lbs, the nearest pound will be 5 lbs. To make it 6 lbs you may need to directly override the value.

"For every expert there is an equal and opposite expert"
Arthur C. Clarke Profiles of the future

 
Status
Not open for further replies.

Part and Inventory Search

Sponsor