Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Toilett Water Surface Area

Thread starter Golestan
Start date Dec 7, 2007

Status: Not open for further replies.

Dec 7, 2007

Golestan

Mechanical

I am not sure if this is the correct forum, but any help will be appreciated. I was looking at a package of plumbing submittals and for water closets, the supplier had the water surface areas listed. Are there any standards on this parameter. What is considered code, good or un-acceptable?

Thanks,