Hello to you all.
I'm trying to work with TolAnalyst but have a tough time doing so, it's fighting me like an alligator it seems.
- for one I do not understand how to set it up correctly using DimXpert, it seems at this stage it's somewhat of a black art. Sometimes it seems to work as expected but it also confuses me on other instances
- second, how do seperate parts need to interact? Do they for instance need to contact each other? This gives me some trouble because I was working on two seperate parts that where not physically touching, it seems this creates problems for the code, not sure though
- third, I'm confused on what kind of GD&T it support's, the help states it only supports certain GD&T rules
Any feedback is more than welcome as always.
I'm trying to work with TolAnalyst but have a tough time doing so, it's fighting me like an alligator it seems.
- for one I do not understand how to set it up correctly using DimXpert, it seems at this stage it's somewhat of a black art. Sometimes it seems to work as expected but it also confuses me on other instances
- second, how do seperate parts need to interact? Do they for instance need to contact each other? This gives me some trouble because I was working on two seperate parts that where not physically touching, it seems this creates problems for the code, not sure though
- third, I'm confused on what kind of GD&T it support's, the help states it only supports certain GD&T rules
Any feedback is more than welcome as always.