Tolanalyst

[moon161]

Is anyone familiar with the SWX Tolanalyst?

I want to do a stackup study with a pump assembly and I'm curious how it works with multiple supports on a bar (shaft in this case)

 

[BiPolarMoment]

I never got a chance to use it--when I asked Dassault if it could handle GD&T (A decade ago) the answer was 'no' so it would have been of limited use anyway.

 

[fraudster]

There are tolanalyst tutorials in solidworks. I think the two main steps are to define datums and gd&t in dimxpert, and then define the assy sequence. Best part is it will generate a report. Good luck

 

[moon161]

Thanks! I have gotten to using it a bit.