Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

tolerance of the dimension

Thread starter ng
Start date Nov 22, 2005

Status: Not open for further replies.

Nov 22, 2005

ng

Mechanical

Hi Friends,
I am trying to extract the tolerance of a dimension in a drawing mode using J-Link. but J-Link is not allowing to typecast BaseDimension/Dimension2D in to Dimension Type obj.
is there any work around method?
Thanks in adavnce
Nikhil Gothankar