Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Tolerance stack up of Form

Thread starter rfhall
Start date Sep 12, 2006

Status: Not open for further replies.

Sep 12, 2006

rfhall

Mechanical

Ineed to perform a tolerance stackup to include form requirements (profile, parallelism, etc)

What is the best way to perform this. I am planning to do a Monte Carlo analysis. Is Normal distribution correct

Is there a web site with sample that may help.

Thanks