Tolerance stackup checking with SW Standard?

[TeejT]

Does the Standard version of SW have a tolerance stackup checking function that I haven't been able to find? I could use something like that even for screws/hole depths all the time! Or do I have to simply do the arithmetic in my notebook by hand? Thanks!

 

[SteveMartin]

The only tolerance analysis I know of within SolidWorks is part of SolidWorks Professional. I don't believe anything exists in Standard for this task.

 

[ShaggyPE]

As Steve pointed out, Tolerance Analysis is only available in premium. You may be able to make use of Interference Detection to confirm hole depths for fasteners.

-Dustin
Professional Engineer
Pretty good with SolidWorks