Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Tolerance Standards (A. I. 2400)

Status
Not open for further replies.
billference

billference

Mechanical
Dec 11, 2003
1
Can anyone tell me anything about this standard that was referenced in the title block of my customer's (GM) drawing?
 
Status
Not open for further replies.

Similar threads

ShlomoB
  • Locked
  • Question
Adding the same balloon multiple times in a drawing (ANSI) 1
Replies
3
Views
968
ewh
ewh
Tmoose
  • Locked
  • Question
ANSI Standard tolerances - B4.1 - but not just cylindrical fits
Replies
0
Views
400
Tmoose
Tmoose
Harry Houdini
  • Locked
  • Question
Standards Regarding Counterbore Clearance Holes for Various Screw Types
Replies
0
Views
1K
Harry Houdini
Harry Houdini
fabeljafla
  • Locked
  • Question
API Source Inspector Electrical Equipment (SIEE) help ............
Replies
0
Views
433
fabeljafla
fabeljafla
changedsoul
  • Locked
  • Question
USAS Y14.5-66 MMC Implied???? 1
Replies
7
Views
486
looslib
looslib

Part and Inventory Search

Sponsor

Back
Top Bottom