Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Tolerances in Hole Callouts

Status
Not open for further replies.

adicm

Mechanical
Dec 4, 2003
39
Hi. It is possible to add a tolerance in a counterbore or countersink hole callout? I need to make a counterbore hole, but with tolerances, and I don't know if this is even possible.

THank You

Adi
 
Replies continue below

Recommended for you

Yes, somewhat. You can put +/- (use variable) in the text box, then put .002 after it.

Bradley
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor