toolbars, SolidWorks 2008

[jerry1423]

It is easy to place an icon on a toolbar, by dragging and dropping, but ...
How can I remove an icon (that I don't use) from a toolbar?

 

[handleman]

Well, to add an icon, you drag it onto the toolbar and drop it. Have you tried dragging the unwanted icon off the toolbar and dropping it?

-handleman, CSWP (The new, easy test)

 

[4zengineering]

Keep in mind that you need to have the same "Customize" window open that you would have if you were adding an icon.

 

[jerry1423]

Thanks for the replies ...
What I did was go back into "customize" and drag the icons into there. In other words I went to the same place that I pulled icons from, and put them back.

 

[CorBlimeyLimey]

You don't need to actually put them back into the Customize selection box, just dragging them outside of the toolbar does the job.