Toolbox component locations

[DUBOISM]

I am using 2004 sp0 with Toolbox. Is there a way to specify where Toolbox saves its generated components? Problem is it defaults to save them on local drive, I would prefer to save them with there project on the network, to avoid un-resolved file links. Thanks

 

[Figbash]

Our Toolbox data is stored on the network. When we installed SolidWorks, it asked where we would like to store our data files and we specified a mapped drive on our network. I don't know if that location can be changed after installation or not. I guess that you could always re-install.

Tom

 

[Figbash]

I was just looking at the SolidWorks FAQ's and there is a section on Toolbox that will tell you everything that you need to know.

Tom