Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Top Angle

Status
Not open for further replies.
SilentVoice

SilentVoice

Structural
Jun 3, 2009
5
Hi,

Is any one knows about the critera to select the Top angle size with tank dia 27.4m and height 17m having no internal pressure?
Thanks
 
Replies continue below

Recommended for you

Sort by date Sort by votes
See 5.1.5.9 in API-650 11th Ed., assuming this is an API-650 tank.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

TheEverest
  • Locked
  • Question
Maximum Stress for top plate and chair height (AISI Steel Plate Engg. VOL 2 Anchor Chair Design)
Replies
8
Views
164
HTURKAK
HTURKAK
jfacevedob
  • Locked
  • Question
API 653 Reinforce of a last shell rim and top angle
Replies
4
Views
91
jfacevedob
jfacevedob
thaierali
  • Locked
  • Question
how i decide to replace top shell of a fuel tank according to API653 1
Replies
1
Views
26
JStephen
JStephen
PogingLamig1
  • Locked
  • Question
Top Angle or Compression Ring
Replies
2
Views
121
PogingLamig1
PogingLamig1
senthil83
  • Locked
  • Question
design of tank top shell curb angle for Flat roof
Replies
2
Views
19
JStephen
JStephen

Part and Inventory Search

Sponsor

Back
Top Bottom