MohdYaseen2010
Mechanical
- Nov 26, 2007
- 101
(A) I have Understood that Top Curb Angle (Figure F.2) shall be provided if 5.9.5.2 condition met (Top Wind Girder (per Table 5.19a & Figure 5.24) is located more than 0.6 m below the Top of Shell) or in case of Open Tank.
Am I correct?
Also, when Top Wind Girder as per 5.9.5 shall be provided?
(B) 5.9.5.2 stated that Top Curb Angle shall be 65 x 65 x 6 mm and 75 x 75 x 6 mm for Shells 5 mm Thick and for Shells > 5 mm Thick respectively; while as per 5.1.5.9 (e), the Top Curb Angle shall be 50 x 50 x 5 mm, 50 x 50 x 6 mm, 75 x 75 x 10 mm for D ≤ 11 m, 11 m < D ≤ 18 m and D > 18 m respectively.
Which when shall I follow?
(C) Is Top Curb Angle or Top Wind Girder is the same as the End Stiffener mentioned in V.8.2.3 (particularly Top Stiffener)?
Mohd Yaseen
Am I correct?
Also, when Top Wind Girder as per 5.9.5 shall be provided?
(B) 5.9.5.2 stated that Top Curb Angle shall be 65 x 65 x 6 mm and 75 x 75 x 6 mm for Shells 5 mm Thick and for Shells > 5 mm Thick respectively; while as per 5.1.5.9 (e), the Top Curb Angle shall be 50 x 50 x 5 mm, 50 x 50 x 6 mm, 75 x 75 x 10 mm for D ≤ 11 m, 11 m < D ≤ 18 m and D > 18 m respectively.
Which when shall I follow?
(C) Is Top Curb Angle or Top Wind Girder is the same as the End Stiffener mentioned in V.8.2.3 (particularly Top Stiffener)?
Mohd Yaseen