Franklin M.
Aerospace
- Jan 20, 2018
- 59
Gentlemen.
I'm transitioning for V6 to V12. I'm an NC programmer so the bulk of questions will be CAM related. My thought is posting questions here will be quicker in the long run than calling CTAC or my re-seller (who tries but is frequently lacking). Though I find the new menus cumbersome and slower than their predecessors I will try to refrain from whining and move on.
So here are my first questions. In a Planar mill oper in V6 I could change the plane of the boundary using select/complete when editing the boundaries. It would appear I have select each boundary and restate the plane in v12.
NX12 also wants to create an interpart link for each piece of geometry I use as a part surface. Should I just promote the whole part and be done with it or I can turn the linking off in Users Defaults. Speaking of which where in the User Defaults is the pointer for Assembly Load behavior (i.e. from folder, as saved etc).
Regards, Frank
I'm transitioning for V6 to V12. I'm an NC programmer so the bulk of questions will be CAM related. My thought is posting questions here will be quicker in the long run than calling CTAC or my re-seller (who tries but is frequently lacking). Though I find the new menus cumbersome and slower than their predecessors I will try to refrain from whining and move on.
So here are my first questions. In a Planar mill oper in V6 I could change the plane of the boundary using select/complete when editing the boundaries. It would appear I have select each boundary and restate the plane in v12.
NX12 also wants to create an interpart link for each piece of geometry I use as a part surface. Should I just promote the whole part and be done with it or I can turn the linking off in Users Defaults. Speaking of which where in the User Defaults is the pointer for Assembly Load behavior (i.e. from folder, as saved etc).
Regards, Frank