Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Translation in NX 7.5

Status
Not open for further replies.

illustrator15

Mechanical
Apr 4, 2011
16
DK
Hi All,

I am using NX 7.5 and I want to make step file of an assembly. There are two options for exporting step file: Step203 and Step214.

Could anybody tell me what is the difference between them and which option gives a step file containing only outer information and less memory space?

Is parasolid an other option for that?

Thanks in advance,
 
Replies continue below

Recommended for you

I suggest that you try multiple formats together with the receiver of the data. Then select the option that is both simplest and gives the best results.
I experienced a case where we we had trouble sending out data in dxf format and after some discussions with the receiver we found that .cgm was way simpler/faster and 100% reliable for the purpose.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top