True Dimension on ISO view

[cubalibre000]

Hi,
true dimension is born with NX8.
it's possible to dimension an ISO view ?

Thank you...

Using NX 8 and TC9.1

 

[Toost]

I tried. it gives the correct value but the old problem of aligning the dim-lines to the geometry is no difference.
The only workaround i know is expand the view and manipulate the WCS, then create/place the dimension. and finally compensate the size of the dimensions for the scale in the view.

Regards,
Tomas

 

[JohnRBaker]

Try using PMI dimensions.

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:

To an Engineer, the glass is twice as big as it needs to be.

 

[cubalibre000]

I know the solution mentioned by Toost and it's excessive for more then two dimension.
John suggestion need license for PMI.
So I remain that I don't put dimension on ISO view, so much Siemens don't implement in some NX future version.

Thank you...

Using NX 8 and TC9.1

 

[JohnRBaker]

Since this is already doable using PMI, there is NO reason whatsoever for us to waste our time (and resources) adding an additionalbut AND redundant function, which I assume you'd want us to provide free-of-charge, specifically to support the dimensioning of non-orthographic views.

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:

To an Engineer, the glass is twice as big as it needs to be.

 

[cubalibre000]

Sorry John, you have right.

Thank you...

Using NX 8 and TC9.1