Trying to get initials off a drawing in pro e

[nyrangers]

Hi - I'm looking for a way to get initials off a drawing in pro e. Please help.

Thanks,
Marc Weissman

 

[looslib]

Highlight them and delete.

Where are they? Are they in a note or a table?


"Wildfires are dangerous, hard to control, and economically catastrophic."

Ben Loosli
Sr IS Technologist
L-3 Communications

 

[Guest0527211403]

Also check if they are in the drawing format (*.frm). I've seen some people change the formats so they don't have to put the intitals in the title block every time, putting me in a situation not unlike your own.

 

[alphaguru]

Additionally, if the initials are in the format I would suggest creating a parameter in your start part file (Drawn_by) for example. Then you can place a field in your format file referencing that parameter. This way whenever a drawing is started all the drafter must do is set the parameter to the correct name. Set the parameter to "string" I believe.

 

[fighterpilot]

Could also be held in an Intralink only parameter if that is in use.

--
Fighter Pilot
Manufacturing Engineer