Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Tsai hill criterion

Status
Not open for further replies.
Ledub33

Ledub33

New member
May 26, 2014
2
0
0
FR
Hello,

I'm working on a layered composite shell part on Abaqus.
I'm using Tsai-Hill criterion to see where the part would yield.
I would like to know if there were anyway to know the percentage of surface in which the criterion has reached a value beyond 1.

Regards.
 
Status
Not open for further replies.

Similar threads

hwa0725
  • Locked
  • Question
ABAQUS Ductile Damage Initiation Criterion
Replies
4
Views
15
hwa0725
hwa0725
Lemine
  • Locked
  • Question
UMAT for perfectly plastic using Von mises criterion ?
Replies
1
Views
9
ehsan11
ehsan11
alijameel
  • Locked
  • Question
Tsai-Wu in Abaqus
Replies
2
Views
3
SWComposites
SWComposites
kukogoba
  • Locked
  • Question
TSAI WU, TSAI HILL ABAQUS 6.13.
Replies
0
Views
1
kukogoba
kukogoba
kukogoba
  • Locked
  • Question
TSAI WU
Replies
0
Views
1
kukogoba
kukogoba
Back
Top