Dec 10, 2004 #1 soya Mechanical Dec 9, 2004 11 0 0 GB Dear friends, I would like to know the way to design a simple tube and sheet heat exchanger. Thanks.
Dec 10, 2004 1 #2 athomas236 Mechanical Jul 1, 2002 607 0 0 GB Try this http://www.wlv.com/products/databook/ athomas236 Upvote 0 Downvote
Dec 10, 2004 #3 tickle Chemical Mar 19, 2003 310 0 0 AU Mechanical design or thermal design? Transfering heat from what to what? What exactly are you asking? I actually think that your post should be red flagged due to the lack of information you provide compared to the amount that you are asking for. Upvote 0 Downvote
Mechanical design or thermal design? Transfering heat from what to what? What exactly are you asking? I actually think that your post should be red flagged due to the lack of information you provide compared to the amount that you are asking for.
Dec 12, 2004 1 #4 WebWizz Mechanical May 31, 2004 30 0 0 NL Check http://www.engineeringpage.com The tentative sizing routine found as the first calculation form on http://www.engineeringpage.com/nav/he.html will give you a simle way to get an idea of the area needed. If you feel like doing the full calculation, use the thermal rating routine after that. Best Regards, Wim Upvote 0 Downvote
Check http://www.engineeringpage.com The tentative sizing routine found as the first calculation form on http://www.engineeringpage.com/nav/he.html will give you a simle way to get an idea of the area needed. If you feel like doing the full calculation, use the thermal rating routine after that. Best Regards, Wim