EcoMan
Mechanical
- Nov 17, 2001
- 54
Hello,
I would like to test for a difference between a single lot of injection molded parts from each cavity of a symmetric two-cavity mold. I'm not sure whether to use a two-sample t-test or a paired t-test. Which test is appropriate for this case? I assume that the answer doesn't change if there are multiple lots produced under the same processing conditions.
I would like to test for a difference between a single lot of injection molded parts from each cavity of a symmetric two-cavity mold. I'm not sure whether to use a two-sample t-test or a paired t-test. Which test is appropriate for this case? I assume that the answer doesn't change if there are multiple lots produced under the same processing conditions.